E2V Vietnam,Máy gia tốc MG6028 E2V

ABRIDGED DATA Fast tuned pulse magnetron for linear accelerators. The tuning drive will rapidly tune the tube to any point in the frequency range and has been designed to be driven remotely by a DC power supply (see note 1). Tuning range (see note 2) ............................... 10 MHz Peak output power (nominal) ............................ 5.0 MW Magnet and launching section ..........separate electromagnet and launching section assembly MG6030 Isolator (see note 3) ........ use of an isolator is recommended Output ........................................................ no. 10 waveguide (72.14 x 34.04 mm internal) Cooling....................... water and forced-air, or water and SF6 GENERAL DATA Electrical Cathode ....................................................... indirectly heated Heater voltage (see note 4) ............................ 13 V Heater current ................................................. 14 A Heater starting current, peak value, not to be exceeded .................................... 40 A max Cathode pre-heating time (minimum) ............... 6.0 minute Tuner current (see note 5) .............................. 5 A max Tuner coil impedance: at 0 A ........................................................... 6.8  at 5 A (with cooling, see note 6) .................. 8.0  Mechanical Overall dimensions ............................................... see outline Net weight ......................................................... 8 kg approx Mounting position ............................................................. any Accessories Electromagnet/launching section ............................. MG6030 Sidearm radiation absorber ...................................... MG6016 1 F coaxial capacitor (see note 4) .......................... MA997A Cooling The magnetron anode and the electromagnet have integral water jackets. The magnetron requires a water flow of 18 to 27 litres/minute; the pressure drop across the water jacket is 103 kPa maximum. The electromagnet requires a water flow of 4.5 litre/minute at a pressure drop of 14 kPa. The magnetron output window may be cooled by either high pressure air or an arc suppressant gas such as SF6. When the output window is cooled by high pressure air, a flow of not less than 0.085 m3 /minute (NTP) into the air inlet at the base of the launching section is required. If SF6 is used, then no gas flow is required to cool the window. See note 7. Low pressure air cooling may be required for the cathode terminal.  

=====================================================

Đại lý phân phối chính hãng E2V tại Vietnam 

Báo giá ngay – Hàng chính hãng – Bảo hành 12 tháng – Tư vấn hỗ trợ kỹ thuật 24/7 

Xem thêm sản phẩm hãng E2V tại đây

Xem thêm thông tin về thương hiệu khác tại đây

Xem thêm sản phẩm khác tại đây