Main specifications and parameters:

Main Specifications

Maximum input power

Output frequency

Input voltage

Accessibility Features

ZG-UHF3.2

3.2KW

400KHZ-1.1MHZ

Single-phase 220V

50 or 60HZ

Timing function

Main applications and features: 
This product is suitable for many heating purposes, such as:

) Carbide serrated welding

) small shaft and small parts of the heat treatment

) diameter of less than 1mm stainless steel or alloy steel filaments annealing or quenching.
ZG-UHF3.2 series device structure using our third generation inverter control technology, using MOSFET tube as the output frequency power devices, equipment up to 1.1 MHz , the device power is small, low physique, suitable for heating a number of small parts, especially in the brazed carbide teeth welding industry has a wide range of applications.

The main advantage of induction heating is

  ① do not have the overall heating, the workpiece deformation is small, the power consumption is small.

  ② pollution. 

  ③ heating speed, less surface oxidation and decarbonization. 

  ④ surface hardened layer can be adjusted as needed, easy to control. 

  ⑤ heating equipment can be installed in the mechanical processing production line, easy to implement mechanization and automation, easy to manage, and can reduce the transport, saving manpower, improve production efficiency. 

  ⑥ hardened layer of fine martensite, hardness, strength and toughness are higher. 

  After surface hardening of the workpiece surface ⑦ have larger compressive stress, anti-fatigue workpiece higher breaking capacity.

Induction heating heat treatment also has some drawbacks

  Compared with the flame hardening, induction heating equipment more complex, and poor adaptability to certain complex shape of the workpiece is difficult to guarantee quality. 

  Induction heating is widely used for surface hardening gears, shafts, crankshafts, cam, rollers and other parts, aims to improve the wear resistance of these artifacts and the ability of anti-fatigue breaking. After the vehicle axle induction heating surface hardening, fatigue cycles under design loads higher than quenching with approximately 10 -fold.Induction heating surface hardening of the workpiece material is usually carbon steel. In order to meet the special needs of certain artifacts, it has been developed for induction heating surface hardening a dedicated low-hardenability steel.High-carbon steel and cast iron workpieces can also employ induction heating surface hardening. Quenching medium commonly used in water or polymer solution.